Dear Sir
25 Years experience in Electrical Field (Manufacturing Industry & Construction)

• Bill of Quantity, Scope of Work, Material submittals, Scheduled & task completion
• Power Distribution (Low voltage) short circuit , commissioning testing, Inspection troubleshooting industrial & domestic, SWGR, AutoCAD Panel Scheduled., UPS, Fire Pump, Lift station, HVAC, CCTV, fire alarm, battery charging room, Generator, ATS, transformer, PVC Cables 0.6Kv (armored unarmored) cable race way and layout. Surge Arrester, Lighting Arresters.
• Familiar with NEC Codes Safety standards NFPA 70
• Familiar with Lockout & tag out human safety system
• Circuit Designing repairing & troubleshooting 24 VDC, 110 VAC, 230 VAC & 480 VAC
• VFD, Servo Drive ,3 Phase Motor maintenance overhauling 0.25 Kw – 250 Kw
• PLC building & programming Mitsubishi, Fatek, Siemens S7 300, WinCC SCADA,weintek HMI, (Mtv-100 with LED TV), VFDs , 0-10V , 4-20 m A, in/out Analog & Digital circuit
• Expert and resistance Utilize megger multimeters (volts, amps)
• AutoCAD Designing, Single line drawing, power & control panels, fire alarm, cable tray, electrical shop drawings etc.
• Installation, Troubleshooting, repairing , Fire Pump, Sprinkling control
• Complete electrical control and instrumentation system design including P&ID drawings, control system architecture, and instrumentation system.
• Installation, repair, testes branch circuits, conduit lines, switch boxes, lighting systems, fixtures, and other electrical equipment, AC/DC motors, control panels, PLC's, switches and transformers.
• Install, maintain, and troubleshoot relay logic, ladder diagrams, control components-- photo eyes, motor starters, relays, limit switches, proximity sensors, timers, solenoids, Servo drives, frequency inverters, linear drives, encoders, pressure transmitters, Transducer, Load Cell, Ignition transformer, temperature controller thermocouples solid state relays, power supplies 230 / 24 V DC
• Building Grounding & bonding , catweld joint, ground rod 20mm x 3m
• Repairing, troubleshooting mechanical equipments, hydraulic, pneumatic systems, including rotating equipments, bearings, chains, sprockets and gear reducers diagnose and solve problems
• Knowledge of power and pneumatic tools drill, grinder, polisher, sander, screwdriver, wrenches and sockets and all kind of other tools.
• Knowledge of workshop equipment and their uses air compressor, cleaning equipment, grease gun, hoist, jack, lifting equipment, measuring equipment, diagnostic equipment
• Safely operate seizure lift, Lift truck, in cold & dry store.
• Logs scheduled inspection reports of the operating equipment, fixed building equipment and building structures, maintenance, repairs and other records and schedules.
• Must be able to stand/walk for up to 10-12 hours
• Ability to work all days and shifts, including overtime (24 hours a day, 7 days a week operation, including holidays)
• Willing to work flexible shifts depending on requirements.
• Motivated self-starter with the ability to work in a team and independently to able to lift 50 lbs. and pull 100 lbs. as required.
• Ability to pass a pre-employment physical, drug screen and background check

I appreciate your consideration and look forward to further discussion the Electrical job opportunity with you.
I am ready & willing to relocate immediately.
Kind Regards,
Mr Tanveer Hussain